The faucet and the angle stop per the instructions on the supply line, then turn the water on and check for leaks. Instead, the culprit could be the diverter valve, which is responsible for directing the water to the showerhead or the spout. Failed Diverter Valve In some cases, the problem isn’t so simple. Once you have a new supply line, simply attach it to both Reattach the showerhead (if applicable), then check for leakage from the tub spout. We would recommend bringing the old supply line with you to your favorite home improvement retailer to make sure you get an exact replacement. Turn off the water, then disconnect your old supply line by unscrewing itĪt both ends (angle stop and faucet). You'll need to replace the whole supply line (don't worry: it's a pretty cheap fix!). Its a simple fix and cheaper than calling a plumber. If it's still leaking at the supply line, the seal on the supply line might be worn. Dry off the area around the nut, then turn the water back on and check for a leak. Turn the water off at the angle stop, then take an adjustable wrench or groove joint pliers and carefully try to tighten If it's at the point where your supply line connects with the faucet, there's a chance your supply line just needs tightened. Feel free to give us a call at 1-800-PFAUCET to get additional help. Use an adjustable wrench to loosen the bolts. If the faucet is still leaking, you might have another issue. Replacing the stem, or at least the main seat washer at the top, should solve your leaky bathtub faucet problem. Once you have a new supply line, simply attach it to both the faucet and the angle stop per the instructions on the supply line, then turn the water on and check for leaks. Home improvement retailer to make sure you get an exact replacement. We would recommend bringing the old supply line with you to your favorite Turn off the water, then disconnect your old supply line by unscrewing it at both ends (angle stop and faucet). Supply line (don't worry: it's a pretty cheap fix!). Remove the retaining clip that holds the cartridge in place with a screwdriver. Remove the screws holding the escutcheon plate in place and slide out the escutcheon. If it's still leaking at the supply line, the seal on the supply line might be worn. To change a bathtub cartridge, begin by removing the handle as described in Step 1. Turn the water off at the angle stop, then take an adjustable wrench or groove joint pliers and carefully try to tighten the supply line nut until it feels snug.ĭry off the area around the nut, then turn the water back on and check for a leak. If it's at the angle stop, there's a chance your supply line just needs tightened.
0 Comments
Leave a Reply. |